design

Saturday, 15 March 2014

Beaded lariat in silver and grey

This is my first lariat. I believe that I am proud as I have managed to make a necklace from very few components. The trick in this piece is to bunch all of the beads used at the ends so that they make a striking focal point.


The other thing about this lariat is that you don't really need any findings. The necklace is closed by looping one side over the other. I used the new P'Leather to string the beads and it is wonderfully non slip so it can be placed without the fear of your beads ending up in colourful pile on the floor.

So, what do we have to do?

In the picture below are the beads and P'Leather that I used.


You can find them here on Craft Fairy:

Start by cutting your 5 metrese of P'leather into three equal lengths.

On to two of the ends, thread a 4mm rose bead, a platinum spacer, a pink glass bead and a 4mm rose bead. Tie a knot at the end of the p'leather to keep the beads from falling off the end. Then tie another knot after the last rose bead. See below:


Once you have done this on two of the ends, you can add a little variety and thread the third cord ens with a silver oval bead instead.


Before you tie the know in the p'leather stager the length of the cords as shown above. Tie a knot about 10 - 15 cm from the end of the last bead. You don't have to be too precious about this, it all depends on how long you want to have the dangling beads.

Now on two of the cords only, thread on a silver faceted bead. Tie all three cords into a knot after the bead.


Now leave a gap of about 10 cm and tie another knot. Then thread a large pink bead onto 1 thread. You won't be able to get two threads through. Tie a knot after the bead.

Leave another 10 ch and tie a knot. Thread all three cords through one of the platinmum spacers and thie another knot.

Leave 20 cm and tie another knot. Add a platinum spacer and knot. 

Leave 10 cm and tie a knot. Thread on a Silver faceted bead and tie a knot. 

Leave 10cm and tie a knot. Thread on a pink bead and tie a knot.

Now leave a space equivalent to ont of the spaces on the first side of the lariat and tie a knot in just one of the cords. Thread on 1 small bead, 1 silver faceted bead, 1 platinum spacer and 1 small seed bead. Tie a knot trim.

Repeat this with the rest of  the beads to match the first side. I varied it a bit on this side and had two faceted silver beads and just one pink one. That way I ended up with a total of 3 pink beads and three silver beads when the lariat is folded over. Look down to see what I mean.









2 comments: