Ribbon Poinsettia Tutorial

Do you like it? I really hope that you do as I am getting a tutorial ready for you.

The ribbons are available on Craft Fairy and the beads are from my stash.

If you want to make one then all that you have to do is get the follwing ready to play with.

a needle

thread

16mm single faced scarlet ribbon

16mm single faced teal ribbon

scissors

measuring tape.

Start by cutting 5, 7cm pieces of scarlet ribbon and 5, 5cm pieces.

Fold a 7cm piece in half and pinch. Where the pinches are sew together as shown.

Below you will see the two stages together so I hope that this helps.

Now fold the petal on the right side and you will have a pointed petal. If you want really sharp points then you can iron it flat. Repeat with all five petals and lay out side by side on your work space.

Sew along the edge of all of the petals as seen.

Pull the thread tight and the petals will form a circle.

Now repeat the above with 5cm pieces of ribbon and you will get a smaller flower.

Place one flower on top of the other and sew together.

Sew some gold beads to the centre and sew two pieces of teal ribbon to the back for the completed flower.