Saturday, 6 February 2010

Ribbon Flower Tutorial 2

Well! The response to my last flower tutorial was huge so it's spurred me on to do another one and as we have just added fabulous satin dot ribbons to the Craft Fairy site this was an opportunity to use them too.

So above, is the finished flower and now I'm sure that you all want to see how I made it.

First you will need to assemble your ingredients:

On my table I had:
4 strips of hot pink satin swiss dot ribbon each measuring 15 cm.
A few buttons. I hadn't yet decided which ones to use. You will need one bigger than the other though.
A needle. Use a sharp one.
Start your flower by putting some glue on one end of the ribbon:

Fold it to the centre add glue to the other end and fold that to the centre too. Your ribbon should overlap and form a loop that the glue holds together in the centre.

Once you've done this you can layer up the pieces as seen in the picture below and now you're almost ready to sew them together.

I played around with the buttons that I had on the table and I finally chose a pink and a green button as I liked the way that they looked.
You need to be aware that you are sewing a lot of layers of ribbon together so that's why you will need a sharp needle. I started by sewing just two pieces together to get the position right.

Now layer up the pieces and sew together. Add your buttons and sew together and your flower is ready to go...


  1. Pretty, think i'll try this one!

  2. Thank you for sharing, I can't wait to have a go.

  3. Love that flower, will have to give it a try! thank you for passing by my blog and leaving me a comment! much appreciated! Happy stamping and crafting!! HUgs always!

  4. Love it! I've seen this before, but didn't know how to do it. Thank you so much for sharing!! It is greatly appreciated! :o)